6P23H11
5-2
1
2
3
4
5
6
7
8
9
4.
Check the oil pressure. Check for oil
leakage and check the oil pump and oil
strainer if out of specification.
NOTE:
• If the oil pressure sensor is removed, the
engine idle speed will increase about 900
r/min due to an oil pressure sensor mal-
function condition. Delete the diagnosis
record using the YDIS after checking the oil
pressure.
• The actual oil pressure may vary depend-
ing on the temperature and viscosity of the
engine oil being used.
Checking the oil pressure sensor
1.
Connect the test harness to the oil pres-
sure sensor.
2.
Start the engine and warm it up for 5 min-
utes.
3.
Measure the oil pressure sensor input
voltage. Check the wiring harness con-
nection or replace the ECM if out of spec-
ification.
4.
Measure the oil pressure sensor output
voltage. Replace if out of specification.
È
Output voltage
É
Oil pressure
Oil pressure (reference data):
600 kPa (6.0 kgf/cm
2
, 87.0 psi) at
60 °C (140 °F) with SL 10W-30
engine oil and at 900 r/min
S6P25030
Test harness (3 pins): 90890-06869
Oil pressure sensor input voltage
(reference data):
Orange (O) – Black (B)
4.75–5.25 V
Oil pressure sensor output voltage
(reference data):
Pink/white (P/W) – Black (B)
3.4 V at engine idle speed
S6P25040
3.4 V
600 kpa
(6.0 kgf/cm
2
,
87.0 psi)
È
É
Power unit
Summary of Contents for Blue Whale 250 EFI
