6P23H11
6-54
1
2
3
4
5
6
7
8
9
Shimming
NOTE:
•
Shimming is not required when assembling
the original lower case and inner parts.
•
Shimming is required when assembling the
original inner parts and a new lower case.
•
Shimming is required when replacing the
inner part(s).
Selecting the pinion shim
1.
Install the special service tools onto the
drive shaft
1
.
NOTE:
•
Select the shim thickness (T3) by using the
specified measurement(s) and the calcula-
tion formula.
•
Install the special service tool onto the drive
shaft so that the shaft is at the center of the
hole.
•
Tighten the wing nuts another 1/4 of a turn
after they contact the plate
2
.
2.
Install the pinion and pinion nut, and then
tighten the nut to the specified torque.
3.
Measure the distance (M4) between the
special service tool and the pinion as
shown.
NOTE:
Measure the pinion at 3 points to find the dis-
tance average.
4.
Turn the thrust bearing
5
2 or 3 times to
seat the drive shaft housing
6
, and then
measure the housing height (M3) as
shown.
NOTE:
Measure the thrust bearing at 3 points to find
the height average.
Pinion height gauge
3
:
90890-06710
T
R
.
.
Pinion nut:
142 N
·
m (14.2 kgf
·
m, 104.7 ft
·
lb)
Digital caliper
4
: 90890-06704
Shimming (counter rotation model)
Summary of Contents for Blue Whale 250 EFI
