6P23H11
7-18
1
2
3
4
5
6
7
8
9
Removing the PTT unit
1.
Fully tilt the outboard motor up, and then
support it with the tilt stop lever
1
.
WARNING
•
After tilting up the outboard motor, be
sure to support it with the tilt stop lever.
Otherwise, the outboard motor could
suddenly lower if the PTT unit should
lose fluid pressure.
•
When removing the PTT unit with the
power unit installed, be sure to suspend
the outboard motor. If the outboard
motor is not suspended it can fall sud-
denly and result in severe injury.
NOTE:
If the PTT does not operate, turn the manual
valve counter clockwise and tilt the outboard
motor up manually.
2.
Remove the anode
2
and the PTT unit
bolts
3
(8 bolts).
3.
Loosen the self-locking nut
4
of the
through tube, and then move the clamp
brackets slightly in the direction of the
arrows.
WARNING
Do not remove the tilt stop lever
1
from
the clamp brackets.
4.
Remove the PTT motor lead and trim
sensor lead holder
5
and the plastic ties
6
.
5.
Remove the PTT motor lead from the
holder
7
, and then pull out the PTT
motor lead
8
.
6.
Remove the circlip
9
and shaft
0
, then
the upper end of the tilt rod from the
swivel bracket.
7.
Remove the PTT unit
A
.
Clamp bracket and swivel bracket
Summary of Contents for Blue Whale 250 EFI
