SELVA MARINE Blue Whale 250 EFI, Service Manual

Page: 274 / 377

BRKT
Bracket unit
7-19
6P23H11
Removing the clamp bracket
1. Remove the self-locking nut
1
of the
through tube and ground lead
2
, then
clamp brackets
3
and
4
.
2. Remove the trim sensor
5
.
Installing the clamp bracket
1. Install the trim sensor
1
onto the star-
board clamp bracket.
NOTE:
Adjust the trim sensor after installing the PTT
unit. To adjust the trim sensor, see
“ Adjusting
the trim sensor. ”
2. Assemble the clamp brackets and the
swivel bracket by connecting the ground
lead
2
, installing the through tube
3
,
then tightening the self-locking nut
4
temporary.
Installing the PTT unit
1. Fully tilt the outboard motor up, and then
support it with the tilt stop lever
1
.
WARNING
• When installing the PTT unit with the
power unit installed, be sure to suspend
the outboard motor. If the outboard
motor is not suspended it can fall sud-
denly and result in severe injury.
• After tilting the outboard motor up, be
sure to support it with the tilt stop lever.
2. Install the PTT unit mounting bolts
2
onto both clamp brackets together with
the PTT unit
3
, and then tighten them.
T
R
.
.
Grease nipple
5
:
3 N · m (0.3 kgf · m, 2.2 ft · lb)