SELVA MARINE Blue Whale 250 EFI, Service Manual

Page: 299 / 377

6P23H11
7-44
1
2
3
4
5
6
7
8
9
NOTE:
Align the armature shaft with the recess in
the joint.
Installing the reservoir
1. Install the spacer
1
, filter
2
and sheet
3
to the PTT body.
2. Install the new O-ring
4
and reservoir
5
, and then tighten the bolts
6
to the
specified torque.
3. Install the reservoir cap
7
, and then
tighten it to the specified torque.
Installing the tilt ram
1. Fill the tilt cylinder with the recommended
fluid to the correct level
a
as shown.
2. Add a small amount of the recommended
fluid through the PTT body hole
b
as
shown.
3. Install the tilt piston assembly into the tilt
cylinder, and then tighten the tilt cylinder
end screw
1
to the specified torque.
NOTE:
Place the tilt cylinder end screw at the bottom
of the tilt ram
a
and install the tilt piston
assembly into the tilt cylinder.
T
R
.
.
PTT motor mounting bolt
4
:
19 N · m (1.9 kgf · m, 14.0 ft · lb)
T
R
.
.
Reservoir mounting bolt
6
:
19 N · m (1.9 kgf · m, 14.0 ft · lb)
Reservoir cap
7
:
7 N · m (0.7 kgf · m, 5.2 ft · lb)
Cylinder-end screw wrench:
90890-06568
T
R
.
.
Tilt cylinder end screw:
90 N · m (9.0 kgf · m, 66.4 ft · lb)
S6S17140
1
Tilt cylinder and trim cylinder