SAMWONTECH
2nd Edition of TEMP2000M_Series IM : April. 8. 2014 Page 88 / 176
11. Sensor input
11.1 Sensor input setting
11.1.1 Sensor input the 1
st
screen
▶
Temperature (T/C, RTD, DCV) sensor is selected.
☞
The sensor setting shall be set at first certainly.
①
It sets the input sensor.
☞
Parameter for the unit described with EU and EUS shall be changed proportionally with the current
data in case of sensor change. However, the upper·lower range setting data is initialized.
☞
It cannot be changed during operation. .
②
It determines the type of input sensor.
☞
The setting screen is displayed [Fig. 11-2 Sensor type setting screen (In case of T/C setting.)].
☞
Refer to [Table 11-1. Sensor input setting the 1
st
screen parameter].
③
It set the display unit.
☞
The setting screen is displayed like [Fig. 11-3 Display unit setting screen (In case of T/C setting.)].
☞
Refer to [Table 11-1. Sensor input setting the 1
st
screen parameter]
④
It sets the use/non-use of thermocouple.
☞
It selects the use/non-use of RJC when the sensory type is T/C.
⑤
It moves to [Fig. 10-1 Main screen].
⑥
It sets the scope of use for the set sensor.
☞
The parameter related with EU and EUS such as auto tuning and alarm can be changed in its
operation point and setting data at the changes of the Lower limit range (RL) and Upper limit range
(RH).
☞
Refer to [Table 11-1. Sensor input setting the
1st
screen parameter]
⑦
It moves from present screen to the next screen.
⑧
Input calibration (BIAS function)
☞
It calibrates the temperature input deviation.
⑨
Sensor filter
☞
It sets the sensor filter time when the high frequency noise is included into input signal.
⑩
The operation direction for the PV (Present Value) is set in case of sensor disconnection.
⑪
It moves to [Fig. 10-3 System parameter setting screen].
①
②
③
④
⑤
⑪
⑦
[Fig. 11-1] Input sensor setting the 1
st
screen (In case of T/C setting.)
⑥
⑩
⑧
⑨
Summary of Contents for Temp 2000 M
Page 1: ...Instruction Manual...
