SAMWONTECH
2nd Edition of TEMP2000M_Series IM : April. 8. 2014 Page 157 / 176
22.3 Sub channel sensor input setting
▶
It selects the sensor input setting of sub channel in [Fig. 22-2 Sub channel system parameter setting
screen].
▶
Sensor setting shall be set at the first.
①
It sets the input sensor of sub channel. Refer to [Table 22-2 Sensor No.].
☞
Parameter for the unit described with EU and EUS shall be changed proportionally with the current
data in case of sensor change. However, the upper·lower range setting data is initialized.
☞
It cannot be changed during operation.
②
It sets the scope of use for the set sensor.
☞
The parameter related with EU and EUS such as auto tuning and alarm can be changed in its
operation point and setting data at the changes of the Lower limit range (RL) and Upper limit range
(RH).
☞
Refer to [Table 22-1. Sensor input setting the
1st
screen parameter of sub channel]
③
It sets the use/non-use of thermocouple.
☞
It selects the use/non-use of RJC when the sensory type is T/C.
④
It selects the group of channel to be applied in case of parameter change.
☞
It changes only the parameter of channel selected currently.
☞
It changes the parameter of every channel as same.
⑤
Sensor filter
☞
The sensor filter time is set when the high frequency noise is included into the input signal.
⑥
It moves the screen to the next and previous screen.
⑦
Input calibration (BIAS function)
☞
It calibrates temperature input deviation.
⑧
It moves to the corresponding channel in when the parameter is set.
⑨
It sets the operation direction of the PV (Present Value) in case of sensor disconnection.
⑩
It is a table to be list the representative sensor No. when the sensor type is selected.
⑪
It moves to [Fig. 22-2 System parameter setting screen].
[Fig. 22-3] Input sensor setting the 1
st
screen of sub channel (In case of T/C setting.)
①
②
③
④
⑦
⑨
⑩
⑪
⑥
⑧
⑤
Summary of Contents for Temp 2000 M
Page 1: ...Instruction Manual...
