Ross Synergy MD, Engineering Manual, Page: 267 / 388

Synergy Q/MD Engineering Manual (v9.1 MD) Custom Controls • 10–21
Insert Special — Special Menu
6. Assign the reset GPI to a GPI output as follows:
• Use the
Selection
knob to select
Reset GPI
.
• Use the
GPI Output
knob to select the GPI output port you want to reset.
7. Press
Insert
to insert the selected command into the custom control and display the
Insert Special Menu 1-2 .
8. Insert additional commands if needed. When you have finished inserting commands,
proceed to the next step to complete the procedure.
9. Press
UP ONE
to display the Recording Menu .
Custom Controls — Recording Menu
10. Press
Finish Recording
to finish recording to the selected custom control. The custom
control button will stop flashing.
This completes the procedure for programming a GPI reset.
Trigger GPI
Use the following procedure to program a GPI output trigger:
1. Navigate to the Custom Controls Menu 1-2 as follows:
• Press HOME
B
Custom Controls .
Note The names that appear in the GPI Output list will also be shown when
editing the custom control. The names are programmed on the GPI
Output Setup Menu . Refer to the section “ Standard GPI Setup ” on
page 11-17 for details.