Ross Synergy MD, Engineering Manual, Page: 202 / 388

7–32 • BNC Configuration and Check Synergy Q/MD Engineering Manual (v9.1 MD)
Sample Keyer State
4. Visually check the appearance of the Key on the monitor:
• The assigned Alpha signal should be properly cutting the hole in the background.
• The selected Fill signal should be properly filling the hole.
• The edges of the Key should be clean.
5. If the Key does not appear correct, check the display. The Auto Key Setup Menu
appears automatically each time you take a Key on-air. A sample menu is shown below:
Auto Key Setup Menu
In the Main Area of the menu, ensure that:
• The correct MLE and Keyer are shown.
• The correct Key Fill source name and BNC number are shown.
• The correct Key Alpha source name and BNC number are shown.
• The correct Key Attributes are shown (e.g., shaped).
6. If the Key Alpha and Fill sources are incorrectly paired or improperly assigned , check
the associations for the alpha and fill signals on the following setup menus:
• BNC Names Menu
• BNC Type Menu
• Alpha Setup Menu
• Auto Key Setup Menu
• Panel Setup Menu
Refer to the appropriate sections earlier in this chapter for instructions.
MLE 1 KEY 1
MATTE
FILL
SELF
KEY
KEY
MEM
ON
AUTO
SELECT
KEY
PV
KEY
OVER
AUTO
TRANS
CHROMA
KEY
FLY
KEY
PST
PATT
BORD
SHDW
OUTL
BORD
OFF
CUT
MASK
KEY
INV