Ross Synergy MD, Engineering Manual, Page: 262 / 388

10–16 • Custom Controls Synergy Q/MD Engineering Manual (v9.1 MD)
4. Press
Start Relative Recording
to display the Recording Menu .
Custom Controls — Recording Menu
5. With the recording in progress, press the buttons on the control panel that you would like
to have played back, in order. All subsequent keystrokes will be remembered, in the
exact order that you press them .
6. Insert any special functions you want as follows:
• Press
Insert Special
to display the Insert Special Menu 1-2 .
• Refer to the section “ Programming Special Functions ” on page 10-18 for
information on inserting special functions.
7. Press
Finish Recording
when you have finished recording the macro.
Custom Controls Menu
You will notice an “@” symbol next to the custom control you just recorded, indicating
that this relative custom control contains information.
This completes the procedure for recording a relative custom control.
Running Multiple Custom Controls
The Multiple Custom Controls feature allows you to have a single custom control start multiple other
custom controls, or you can manually start multiple custom controls using the corresponding custom
control buttons. All the custom controls will continue to play out until they reach the end, or loop.
Note Press Cancel Recording to terminate the programming procedure.
The macro will not be recorded.
Operating
Tip
You can insert a Stop Other Custom Controls command that will stop
all other running custom controls, except the one that is currently
running. Refer to the section “
Stop Other Custom Controls ” on
page 10-31 for more information.