Ross Synergy MD, Engineering Manual, Page: 258 / 388

10–12 • Custom Controls Synergy Q/MD Engineering Manual (v9.1 MD)
3. Press
Start Recording
to display the Recording Menu .
Custom Controls — Recording Menu
4. With the recording in progress, press the buttons on the control panel that you would like
to have played back — in order. All subsequent keystrokes will be remembered, in the
exact order that you press them . The following is a list of examples of custom controls
that can be recorded:
5. Insert any special functions you want. You can insert any of the following:
• VTR Functions — Refer to the chapters “ VTRs (Betacam) ” or “ Video Servers
(VDCP) ”.
• Time Clock Functions — Refer to the section “ Time Clock Functions ” on
page 10-18.
• Special Functions — Refer to the section “ Special Functions ” on page 10-20.
• Pbus — Refer to the section “ Pbus ” on page 10-35.
• Character Generator Custom Controls — Refer to the chapter “ Character
Generators ”.
• Router Custom Controls — Refer to the chapter, “ Routers ”.
• Robotic Camera Custom Controls — Refer to the chapter, “ Robotic Cameras ”.
• Audio Server Custom Controls — Refer to the chapter, “ Audio Servers ”.
• Monitor Wall Custom Controls — Refer to the chapter, “ Monitor Walls ”.
6. Press
Finish Recording
when you have finished recording the macro.
Note Press Cancel Recording to terminate the programming procedure.
The macro will not be recorded.
Important Custom Controls will not recall the sources assigned to a particular bus
map, only the crosspoint buttons that were pressed. If you are using
different bus maps, you must ensure that the same bus map is used
when you run the custom control as when you created the custom
control.