Ross Synergy MD, Engineering Manual, Page: 126 / 388

4–26 • Preliminary Cabling and Video Installation Synergy Q/MD Engineering Manual (v9.1 MD)
3. Remove the lens cap from the lens, and place the desired input designation under the
lens cap.
This completes the procedure for installing control panel pushbutton inserts.
Please note:
• When reinstalling the lens assembly, line up the locating lugs on the lens with the
locating slots in the primary input switch. Otherwise, the lens cap may pop off when the
switch is pressed and released.
• The designation film must read correctly with the lens locating lugs at the sides, not at
the top and bottom.
Remote Aux Panel Pushbutton Inserts
Use the following procedure to install all remote Aux panel pushbutton inserts. Use the diagram
below for reference.
1. Cut out designation film inserts for remote Aux panel pushbuttons in all remote Aux
panels. Note that the inserts used will be the same as those used for the switcher primary
inputs, with the exception that Aux panels do
not have Color Background labels.
2. Remove the lens cap by placing a fingernail under the side of the cap and gently pulling
upward.
3. Position the insert in the lens cap.
4. Replace the paper background, then replace the lens cap on the switch and button
assembly.
5. Press down firmly to re-seat the cap.
This completes the procedure for installing all remote Aux panel pushbutton inserts.
Important Perform this procedure for all buttons on each PGM , PST , BKGD ,
and KEY bus on your switcher. In addition, install pushbutton inserts
for each of the eight Key Bus crosspoints in each Downstream Keyer
( Synergy 2 and 3 control panels only).
Transparent Lens Cap
Designation Insert
(may be colored)
White Paper Background
Switch and Button Assembly