Ross Synergy MD, Engineering Manual, Page: 319 / 388

Synergy Q/MD Engineering Manual (v9.1 MD) Additional Installation Setups • 11–17
Standard GPI Setup
The GPI I/O Setup Menu allows you to set up your 10 “standard” GPI Input ports and 10 GPI Output
ports. All 20 ports are provided on the GPI I/O connector. Refer to the section “ GPI I/O and System
Fail Relay Connections ” on page 3-36 for wiring instructions. Before setting up your GPIs, please
complete the following worksheets.
Standard GPI Input Worksheet
Complete the following Standard GPI Input Worksheet for each standard GPI input port (1 to 10):
• In the
Event Type
column, fill in the type of event that you want to trigger. Choose
between:
~ Off
~ Auto
~ Cut
~ Cust Ctrl
~ Mem Recall
• In the
Event Area
column, fill in the area of the switcher where you would like the
event to occur. You can select between the following:
~ MLE 1
~ MLE 2
~ MLE 3
~ Fade to black (DSK)
~ MultiDSK 3
~ MultiDSK 4
~ Custom Control name and number
~ Memory name and number
• In the
Polarity
column, fill in the polarity of the input trigger. Choose between:
~ Low
~ High
Operating
Tip
To avoid marking up the Engineering Manual , use the worksheet
provided in Appendix C “ Installation Worksheets ” to make extra
copies.