Rohde & Schwarz NRPM OTA Power Measurement Solution, Manual

Page: 177 / 229

Remote control commands
R&S
®
NRPM
177 Mannual 1425.8663.02 ─ 08
Parameters:
<level> Range: 1.0e-7 to 200.0e-3
*RST: 1.0e-3
Default unit: W
Manual operation: See "Trigger Level" on page 79
TRIGger:LEVel:UNIT <unit>
Sets the unit of the trigger level if this value is entered without a unit.
See
TRIGger:LEVel
.
Parameters:
<unit> DBM | W | DBUV
*RST:
W
Example: TRIGger:LEVel:UNIT W
Manual operation: See "Trigger Level" on page 79
TRIGger:SENDer:PORT <sender_port>
Selects the port where the R&S NRPM provides its internal trigger signal at the
output, provided it is trigger sender (see
TRIGger:SENDer:STATe
).
You can assign either the port
EXTernal[1]
or
EXTernal2
for the trigger
sender. If you want to trigger the sender sensor module externally with its own
trigger signal, assign the trigger source to the other port accordingly, e.g:
TRIGger:SENDer:PORT EXT1
TRIGger:SOURce EXT2
TRIGger:SENDer:
STATe
ON
or
TRIGger:SENDer:PORT EXT2
TRIGger:SOURce EXT1
TRIGger:SENDer:
STATe
ON
Configuring the trigger