Rohde & Schwarz NRPM OTA Power Measurement Solution, Manual

Page: 156 / 229

Remote control commands
R&S
®
NRPM
156 Mannual 1425.8663.02 ─ 08
Parameters:
<count> Range: 1 to 8192
*RST: 1
Example: [SENSe<Sensor>:][POWer:][AVG:]BUFFer:SIZE
10
[SENSe<Sensor>:][POWer:][AVG:]BUFFer:STATe <state>
Enables or disables the buffered continuous average mode. If the buffer mode is
enabled, all results generated by trigger events are collected in the sensor mod-
ule until the buffer is filled.
You can set the size of the buffer using
[SENSe<Sensor>:][POWer:][AVG:
]BUFFer:SIZE
.
Parameters:
<state> *RST: OFF
Example: [SENSe<Sensor>:][POWer:][AVG:]BUFFer:STATe
OFF
[SENSe<Sensor>:][POWer:][AVG:]SMOothing:STATe <state>
Activates the smoothing filter, a steep-edge digital lowpass filter. If you cannot
adjust the aperture time exactly to the modulation period, the filter reduces result
fluctuations caused by modulation.
Parameters:
<state> ON | OFF
*RST:
OFF
Example: SMOothing:STATe OFF
Manual operation: See "Smoothing" on page 73
10.7.2 Configuring a list mode measurement
The list mode measurement enables you to execute a sequence of measure-
ments at various frequency points in continuous average mode automatically.
Remote commands:
Configuring the measurement modes