R&S
NRPM tour
R&S
®
NRPM
36
Mannual 1425.8663.02 ─ 08
5.4
R&S
NRPM-Z3 interface module
For direct connection inside an EM controlled environment, you can use the
R&S
NRPM-Z3 interface module. Plugged directly to the R&S
NRPM3(N) three
channel sensor module, the R&S
NRPM-Z3 interface module can host up to three
antenna modules without additional cables required.
This section introduces the interface module for connecting, e.g. three antenna
module cables for OTA power measurements in an EM-controlled environment, e.
in an RF test chamber.
Figure 5-3: The R&S
NRPM-Z3 interface module
1 = Connector to sensor module
2 = Interface module
3 = Antenna module cable connectors
Connector to sensor module (1)
16-pin push-pull connector for connecting to the sensor module.
Interface module (2)
R&S
NRPM-Z3 three channel interface module to pass up to three antenna mod-
ule cables to one R&S
NRPM3(N) sensor module.
Antenna module cable connectors (3)
Micro miniature connectors (10 pin) for connecting the antenna module cables.
R&S
NRPM-Z3 interface module
