Remote control commands
R&S
®
NRPM
159
Mannual 1425.8663.02 ─ 08
MOVing
Returns each new average trace as a measurement result,
even if the FIR filter is not yet filled completely with mea-
sured traces.
This mode is suitable for measurements, where tendencies
in the result have to be recognized during the measure-
ment procedure.
REPeat
Returns a final trace result only after the FIR filter has
been filled with acquired traces.
This mode is suitable to avoid redundant results in mea-
surements.
*RST:
REPeat
Example:
TRACe:AVERage:TCONtrol REPeat
[SENSe<Sensor>:]TRACe:AVERage[:STATe]
<state>
Activates the averaging filter in trace mode.
Parameters:
<state>
*RST:
ON
[SENSe<Sensor>:]TRACe:DATA?
Returns the measured trace data in a pre-defined format. Unlike the
FETCh?
command, this command considers the settings of
on page 152 as explained below.
Command response
Besides the average power, the R&S
NRPM sensor module can measure addi-
tional measurands like "Minimum", "Maximum" or "Random". These additional
measurands are denoted as auxiliary measurands and are selected by the
Configuring the measurement modes
