Rohde & Schwarz NRPM OTA Power Measurement Solution, Manual

Page: 81 / 229

Performing measurements
R&S
®
NRPM
81 Mannual 1425.8663.02 ─ 08
DHCP
Selects the mode for assigning the IP address.
"Auto"
Assigns the IP address automatically, provided the network sup-
ports DHCP (dynamic host configuration protocol).
"Static" Enables you to assign the IP address manually.
Remote command:
SYSTem:COMMunicate:NETWork:IPADdress:MODE
on page 122
Apply Network Settings
After you have completed the required network settings changes, confirm the
modification with "Apply Network Settings".
Sensor Name
Assigns a name for the sensor module. The web browser-based user interface
indicates the name in the title bar, see
Figure 7-1 .
If you do not specify a sensor name, the hostname is used as default, see
SYSTem:COMMunicate:NETWork[:COMMon]:HOSTname
on page 124.
Remote command:
SYSTem[:SENSor]:NAME
on page 134
Update
Opens a dialog to start the firmware update. For further information, see Chap-
ter 8.2.2, "Using the web browser-based user interface" , on page 86.
Alternatively, you can update the firmware with the firmware update for R&S NRP
family program, see
Chapter 8.2.1, "Using the firmware update for R&S NRP fam-
ily program" , on page 84, or even remotely, see Chapter 8.2.3, "Using remote
control" , on page 87.
Remote command:
SYSTem:FWUPdate
on page 126
SYSTem:FWUPdate:STATus?
on page 127
Selftest
Initiates a selftest of the sensor.
Note:
Do not apply a signal to the sensor module while the selftest is running.
Executing the self-test with an active signal assigned, can erroneously result in
error messages at the test steps
Offset Voltages and/or Noise Voltages .
Measurement applications