Remote control commands
R&S
®
NRPM
170
Mannual 1425.8663.02 ─ 08
The attenuation of an attenuator located ahead of the sensor module (or the cou-
pling attenuation of a directional coupler) is considered with a positive offset, i.e.
the sensor module calculates the power at the input of the attenuator or the direc-
tional coupler. You can use a negative offset to compensate the influence of an
upstream amplifier.
Remote commands:
[SENSe<Sensor>:]CORRection:OFFSet
.................................................................170
[SENSe<Sensor>:]CORRection:OFFSet:STATe
...................................................... 170
[SENSe<Sensor>:]CORRection:OFFSet
<offset>
Sets a fixed offset that is added to correct the measured value.
Parameters:
<offset>
Range:
-200.00 to 200.00
*RST:
0
Default unit: dB
Example:
CORRection:OFFSet 2
Manual operation:
[SENSe<Sensor>:]CORRection:OFFSet:STATe
<state>
Activates the offset correction.
Parameters:
<state>
*RST:
OFF
Example:
CORRection:OFFSet:STATe ON
Manual operation:
10.9
Starting and ending a measurement
.............................................................................................. 171
............................................................................................ 172
Starting and ending a measurement
