Remote control commands
R&S
®
NRPM
161
Mannual 1425.8663.02 ─ 08
User-data-content
In the further description, the term "user data content" is used for the totality of
the contained measurement results.
In the user data content, there are similar mechanisms as with arbitrary block
response data. As indicated above, the user data content can have one or more
blocks with trace measurement results, depending on the selection of auxiliary
measurands. Each section is composed of:
3
5 : (5+x-1)
4
1
2
3
4
5
0 : 2
(5+x) : (5+x+y * (size of data type) – 1)
Figure 10-3: User data content format (byte)
y = number of values which follow the header
x = number of digits of y
1
Result type
Always 3
bytes, one for
AVG
, one for
MIN
and one for
MAX
or
RND
2
Data type
Designator for the contained data type with the size of 1
byte. Currently, the only possi-
ble designator is "f" for 4-byte IEEE754 float data type, little endian.
3
Single digit that defines how many of the following digits are interpreted as the number
of contained float values.
4
User data length
Number consisting of as many digits as specified by (3). This number gives the number
of contained float values contained in the user data.
5
User data
Measurement result values in the format that is described by the data type. Currently
IEEE754 float only.
Configuring the measurement modes
