Remote control commands
R&S
®
NRPM
167
Mannual 1425.8663.02 ─ 08
In this case, previous measurement results still contained in the averaging filter
strongly affect the settling of the display. As a result, the advantage of detecting
trends in the measurement result while the measurement is still in progress, is
lost.
Example:
AVERage:RESet
Usage:
Event
[SENSe<Sensor>:]AVERage:TCONtrol
<mode>
Sets the termination control mode for averaging mode, defining how you retrieve
the measurement results.
When a new measured value is shifted to the FIR filter, a new average value is
available at the filter output. It is composed of the last measured value and the
other values already stored in the filter.
See
Chapter 10.5, "Controlling the measurement"
Parameters:
<mode>
MOVing | REPeat
MOVing
Provides every new average value at the output as a mea-
surement result.
This mode is suitable for measurements, where tendencies
in the result have to be recognized during the measure-
ment procedure.
REPeat
A new result is output after the FIR filter has been filled
with new measured values.
This mode is suitable for measurements, where no redun-
dant information has to be output.
*RST:
REPeat
Example:
AVERage:TCONtrol REPeat
Manual operation:
[SENSe<Sensor>:]AVERage[:STATe]
<state>
Activates the averaging filter for the continuous average mode.
Configuring basic measurement parameters
