Rohde & Schwarz NRPM OTA Power Measurement Solution, Manual

Page: 171 / 229

Remote control commands
R&S
®
NRPM
171 Mannual 1425.8663.02 ─ 08
ABORt
Immediately interrupts the current measurement.
Depending on the selected measurement mode, the trigger system of the sensor
module exits the measuring state and switches to:
●
Idle state
If a single measurement was previously initiated with command
INITiate[:
IMMediate]
, or
INITiate:ALL
.
●
Waiting for trigger
If a continuous measurement was initiated with
INITiate:CONTinuous ON
.
The sensor module starts the next measurement when a trigger event occurs
that meets the set trigger conditions.
Usage: Event
INITiate:ALL
INITiate[:IMMediate]
Starts a single measurement cycle. The sensor module changes from the idle
state to the wait for trigger state. When the trigger condition is fulfilled, the sensor
module starts measuring. Depending on the number of trigger events that are
required, e.g. for averaging, the sensor module enters the wait for trigger state
several times. When the entire measurement is completed, the measurement
readings are available, and the sensor module returns to the idle state.
Use the command only after the continuous measurement mode has been turned
off (
INITiate:CONTinuous OFF
).
Example: See Chapter 11.2, "Performing measurements in continu-
ous average mode" , on page 187.
Usage: Event
Starting and ending a measurement