Rohde & Schwarz NRPM OTA Power Measurement Solution, Manual

Page: 71 / 229

Performing measurements
R&S
®
NRPM
71 Mannual 1425.8663.02 ─ 08
System Status .......................................................................................................71
Measurement ........................................................................................................71
Frequency .............................................................................................................71
Offset .................................................................................................................... 71
└ <State> ...................................................................................................... 71
└ <Value> ......................................................................................................71
S-Parameter ......................................................................................................... 72
Averaging ..............................................................................................................72
System Status
Displayed in the title bar. Confirms that there is a connection between the sensor
and the remote computer and that the sensor is recognized by the software.
The presentation of this symbolic LED mirrors the physical LED of the sensor, see
"Status LED (2)" on page 30.
Measurement
Activates the measurement.
Remote command:
INITiate:CONTinuous
on page 172
Frequency
Sets the carrier frequency of the applied signal. This value is used for frequency-
response correction of the measurement result.
Remote command:
[SENSe<Sensor>:]FREQuency
on page 168
Offset
Sets and enables a level offset.
<State> ← Offset
Activates the level offset.
Remote command:
[SENSe<Sensor>:]CORRection:OFFSet:STATe
on page 170
<Value> ← Offset
Adds a fixed level offset in dB to account for external losses.
Remote command:
[SENSe<Sensor>:]CORRection:OFFSet
on page 170
Measurement applications