Rohde & Schwarz NRPM OTA Power Measurement Solution, Manual

Page: 178 / 229

Remote control commands
R&S
®
NRPM
178 Mannual 1425.8663.02 ─ 08
Parameters:
<sender_port> EXT1 | EXTernal1 | EXT2 | EXTernal2
*RST:
EXT1
TRIGger:SENDer:STATe <state>
Activates the trigger sender mode of the sensor module. In this state, the sensor
module can output a digital trigger signal in synchronization with its own trigger
event.
If activated, select the output port the trigger signal using
TRIGger:SENDer:
PORT
.
Typically, the trigger sender uses its internal trigger source. But you can also trig-
ger the trigger sender externally, since the R&S
NRPM provides two external trig-
ger connectors. If you trigger the sender externally, use
EXTernal1
as external
trigger input port (trigger source) and
EXTernal2
as trigger sender output port or
vice versa.
Parameters:
<state> *RST: OFF
TRIGger:SLOPe <slope>
Available only if
TRIGger:SOURce INTernal/EXTernal
.
Determines what is used for triggering, depending on the trigger source:
●
TRIGger:SOURce INTernal
: uses the rising or falling edge of the envelope
power.
●
TRIGger:SOURce EXTernal
: uses the increasing voltage.
Parameters:
<slope> POSitive | NEGative
*RST:
POSitive
Manual operation: See "<Slope>" on page 78
TRIGger:SOURce <source>
Selects the source for the trigger event detector.
Configuring the trigger