Rohde & Schwarz FSQ series, Quick Start Manual

Page: 85 / 229

Quick Start Guide 1313.9652.62 - 02 2.35
R&S FSQ Preparing for Use
Configuring the LAN Interface
2.5.2 Configuring the Network Card
2.5.2.1 Driver Installation
Under Windows XP, network card drivers do not need to be installed separately.
All you need to do is connect the network cable to the LAN-Interface connector on the
instrument rear panel. Windows XP automatically detects the network connection and
activates the required drivers.
2.5.2.2 Configuring the Interface
To configure the interface, do the following:
➢
Press the SETUP key.
The SETUP menu will open.
➢
Press the GENERAL SETUP softkey.
The submenu with all general settings will open.
➢
Press the CONFIGURE NETWORK softkey .
The dialog box with the network settings will open.
This softkey allows you to change the existing network configuration depending on the
selection of the affected registration cards (see section
“ Configuring Existing Network
Protocols (TCP/IP Protocol)” on page 2.36 ).
IEC bus command:
-
Before you can configure network support, a PC keyboard with a
trackball (or an additional mouse rather than a trackball) must be
connected.