Rohde & Schwarz FSQ series, Quick Start Manual

Page: 73 / 229

Quick Start Guide 1313.9652.62 - 02 2.23
R&S FSQ Preparing for Use
Setup
2.4.3 Setting the GPIB Interface
➢
Press the SETUP key.
The SETUP menu will open.
➢
Press the GENERAL SETUP softkey.
The submenu with general settings will open.
➢
Press the GPIB softkey.
The submenu for setting the parameters of the remote control interface will open.
2.4.3.1 GPIB Address
➢
Press the GPIB ADDRESS softkey.
The entry field for the GPIB address will open.
The setting range is from 0 to 30. The default address is 20 if SCPI is selected as the GPIB
language or 18 if an 85xx emulation is selected.
IEC bus command:
SYST:COMM:GPIB:ADDR 20
2.4.3.2 GPIB Language
➢
Press the GPIB LANGUAGE softkey.
The list of available remote control languages will open.
The following languages are available:
• SCPI
• HP mode:
8560E , 8561E , 8562E , 8563E , 8564E , 8565E, 8566A , 8566B , 8568A , 8568B
71100C , 71200C , 71209A, 8591E , 8594E
If entries of the HP mode are selected, the command recognition uses
syntax rules which are different from syntax rules of the
SCPI mode.
Correspondingly, proper detection of SCPI commands is not ensured
in this mode.
For 8566A/B, 8568A/B and 8594E, command sets A and B are
available. Command sets A and B differ in the rules regarding the
command structure.
Selecting a language different from "SCPI" will set the GPIB address to
18 if it was 20 before. Start / stop frequency, reference level and # of
sweep points will be adapted to the selected instrument model.
8568A_DC and 8568B_DC are using DC input coupling as default if it
is supported by the instrument.
The HP model 8591E is compatible to HP model 8594E, the HP models
71100C, 71200C, and 71209A are compatible to HP models 8566A/B.