151
Error Messages
18 Error Messages
The automatic feeder and the concentrate feeder are continuously monitored by the proces-
sor control. Errors caused are displayed on the screen.
18.1 Checking the Calibration Values of the Milk
If one or more calibration values are missing, the display will
show:
:
Carry out calibration again.
18.2 The Heat Exchanger Is Not Active
If you have not activated the heat exchanger type in Setup, the
display will show:
:
Select the heat exchanger in Setup.
18.3 The Feeding Mode Cuts Off
If the feeding mode cuts off because the temperature has fal-
len below the minimum operating temperature, the display
will show:
:
Check the position of the thermostats.
:
Check the heating.
18.4 The Data Are Deleted
If the data are deleted, a bleep will be emitted. This message
occurs very rarely and only after extremely intensive interfe-
rence on the control. As soon as this message appears, carry
out „New installation, All New“.
Press „0/C“. The display shows „Data destroyed, New Instal-
lation, Yes“.
Refer to chapter 8.2, page 40, „Basic Inputs Du-
ring Installation, New Installation“.
Select „yes“ and press ENTER to confirm the input. The fol-
lowing message will be displayed:
Select „yes“ and press ENTER to confirm the input.
calibration values
adjust !!!
heat exchanger
enter in setup !!
check temperature
data destroyed
press key 0/c
data destroyed
new installationyes
instruction manual
read?
yes
Summary of Contents for TAK5-SA2-KFA-27-F1
