ROBBE TAK5-SA2-KFA-27-F1, Instruction Manual

Page: 42 / 182

42
Setup
8.3 Setup
In Setup you can select the additional functions concerning concentrate, animal scales, heat
exchanger and printing and enter the baud rate for the PC and the concentrate feeders. In
addition, in this menu you can test the interfaces, register and cancel the feeding stations. In
Setup you can also set the draining time.
If the Stand Alone is equipped with a fully automatic heat exchanger cleaning or/and a de-
tergent dosing pump or/and a device for compressed air--cleaning, you have to select these
functions in Setup, too.
As the program is menu--driven, all non--selected functions are not displayed and cannot be
used. If e.g. you do not select the concentrate in Setup, the concentrate menus will not be
displayed.
8.3.1 Activating the Concentrate
Turn program switch to 10 = keyboard.
Enter 5 and press ENTER to confirm the input. The display
shows the menu „Concentrate“.
Press Arrow Right to move to the next screen of submenu
„Concentrate“.
Press Arrow Up or Arrow Down to select the silo .
Enter „yes“ and press ENTER.
Select silo 1 and 2 if 1 Master station with a related Slave station are connected to the fee-
der. Select silo 3 and 4 if 2 Master stations with related Slave stations are connected to the
feeder.
Press Arrow Right to go to the next screen.
Press Arrow Up or Arrow Down to select the silo .
Press ENTER to select the desired concentrate type.
Enter the concentrate type (1 or 2) allocated to the correspon-
ding concentrate feeder and press ENTER to confirm the in-
put.
Press Arrow Right to go to the next screen and select the
group.
5# setup
concentrate ^
➔
5# silo 1&2^
available
no
➔
5# silo 1&2^
available
no
➔
5# silo 1&2
available
yes
➔
5# silo 1^
C1
➔
5# silo 1^
C1
➔
5# silo 1
C1
➔
5# silo 1
C1
➔
5# dosing code
group A^
➔