ROBBE TAK5-SA2-KFA-27-F1, Instruction Manual

Page: 45 / 182

45
Setup
case you have to enter the corresponding output of the serial multiplexer that is connected to
the printer. Printer channel 0 means that no serial multiplexer is connected.
8.3.4 Selecting the Animal Scales
Press Arrow Up or Arrow Down to select menu „Animal Sca-
les“.
Press Arrow Right to move to the next screen.
Select the desired half--body scales. Enter „yes“ and press
ENTER to confirm the input.
You can connect one half--body scales (HS) per feeding station.
Press Arrow Right to go to the next screen.
Press Arrow Up or Arrow Down to select the feeding station
where the animal scales is located.
If e.g. a half--body scales (HS) has been connected to feeding
station 2, enter „yes“ and press ENTER to confirm the input.
Press Arrow Right to move to the next screen.
Press ENTER. Enter the weight factor needed to calculate the
total weight of an animal. Standard value: 178 %.
Press ENTER to confirm the input.
Press Arrow Right to move to the next screen. In this menu
the tare value is automatically ascertained and set.
The processor will convert the electronic signals of the weighing cell of the animal scales
into an indication of weight. This conversion factor (= tare value) is ascertained when put-
ting a weight of approx. 50 kg on the animal scales.
Press Start/Stop, in order to tare the half--body scales.
After tare has been carried out, the display shows:
Press ENTER. Enter the weight value used for weighing.
Standard value: 50 kg.
Press ENTER to confirm the input.
5# setup
animal scales
➔
^
5#anim.scales 1&2^
available no
➔
➔
5#anim.scales 1&2^
available yes
➔
5#anim.scales HS1
feeding box 1^ no
➔
5#anim.scales HS1
feeding box 2^ no
➔
5#anim.scales HS1
feeding box 2^ yes
➔
5#anim.scales HS1
weight factor 178%
5#HS1 tare value
440 set ? start
5#HS1 tare value
tare ..............
5# 50 kg put on
start