Ricoh Type M12, Field Service Manual

Page: 71 / 226

Code Meaning Suggested Cause/Action
22-00
Original length exceeded the
maximum scan length
• Divide the original into more than one page.
• Check the resolution used for scanning. Lower
the scan resolution if possible.
• Add optional page memory.
22-01 Memory overflow while receiving
• Wait for the files in the queue to be sent.
• Delete unnecessary files from memory.
• Transfer the substitute reception files to an
another fax machine, if the machine’s printer is
busy or out of order.
• Add an optional SAF memory card or hard disk.
22-02
Tx or rx job stalled due to line
disconnection at the other end
• The job started normally but did not finish
normally; data may or may not have been
received fully.
• Restart the machine.
22-04
The machine cannot store
received data in the SAF
• Update the ROM
• Replace the FCU.
22-05
No G3 parameter confirmation
answer
• Defective FCU board or firmware.
23-00
Data read timeout during
construction
• Restart the machine.
• Replace the FCU.
25-00
The machine software resets itself
after a fatal transmission error
occurred
• Update the ROM
• Replace the FCU.
F0-xx V.34 modem error • Replace the FCU.
F6-xx SG3 modem error
• Update the SG3 modem ROM.
• Replace the SG3 board.
• Check for line noise or other line problems.
• Try communicating another V.8/V.34 fax.
Error Codes
69