Ricoh Type M12, Field Service Manual

Page: 102 / 226

System Switch 0B - Not used (Do not change the factory settings.)
System Switch 0C - Not used (Do not change the factory settings.)
System Switch 0D - Not used (Do not change the factory settings.)
System Switch 0E (SP No. 1-101-015)
No Function Comments
0-1 Not used Do not change the settings.
2
Enable/disable for direct sending
selection
0: Direct sending off
1: Direct sending on
Direct sending cannot operate when the capture
function is on during sending. Setting this switch to "1"
enables direct sending without capture.
Setting this switch to "0" masks the direct sending
function on the operation panel so direct sending with
ScanRouter cannot be selected.
3
Action when the external handset
goes off-hook
0: Manual tx and rx operation
1: Memory tx and rx operation (the
display remains the same)
0: Manual tx is possible while the external handset is
off-hook. However, manual tx during handset off-
hook may not be sent to a correct direction. Manual
tx is not possible.
1: The display stays in standby mode even when the
external handset is used, so that other people can use
the machine for memory tx operation. Note that
manual tx and rx are not possible with this setting.
4-7 Not used Do not change these settings.
System Switch 0F (SP No. 1-101-016)
No Function Comments
4. Service Tables
100