Ricoh Type M12, Field Service Manual

Page: 52 / 226

Code Meaning Suggested Cause/Action
0-05
Modem training fails even G3
shifts down to 2400 bps.
• Check the line connection.
• Try adjusting the tx level and/or cable
equalizer.
• Replace the FCU.
• Check for line problems.
Cross reference
See error code 0-04.
0-06
The other terminal did not reply to
DCS
• Check the line connection.
• Try adjusting the tx level and/or cable equalizer
settings.
• Replace the FCU.
• The other end may be defective or incompatible;
try sending to another machine.
• Check for line problems.
Cross reference
See error code 0-04.
0-07
No post-message response from
the other end after a page was
sent
• Check the line connection.
• Replace the FCU.
• The other end may have jammed or run out of
paper.
• The other end user may have disconnected the
call.
• Check for a bad line.
• The other end may be defective; try sending to
another machine.
3. Troubleshooting
50