Ricoh G148, Service Manual

Page: 92 / 537

4. Slide the punch unit [4] along its rails into the finisher. Make sure that pin engages correctly
at the front and rear.
5. Connect and fasten the punch unit [5] (

x 2,

x 1).
• The connectors [6] are coiled and tied above the PCB on the right.
6. Fasten the slide drive unit [7] to finisher and connect it to the punch unit (  x 2,  x 1).
Press in on the slide drive unit at
¶
when you attach screw
·
.
7. Make sure that the punch unit moves freely and is not blocked by the screws.
8. Insert the side-to-side detection unit [8]. Make sure that the two pins are engaged correctly
at the front.
Punch Unit (B702)
91
1