Ricoh G148, Service Manual

Page: 93 / 537

9. Confirm that the side-to-side detection slides smoothly on its rails. If it does not, make sure
that the rails are aligned with their grooves.
10. Fasten the side-to-side detection unit and connect it at the rear (

x 2,

x 1,

x 1).
11. Pull the short connector out of the connector [9] then connect it (

x 1).
• This is the 3-pin connector.
12. At the front, use a pair of nippers to remove the knockout [10]
13. Insert the punch waste transport unit [11] into the finisher.
• Make sure that the punch waste transport unit slides smoothly on its rails. If it does not, make
sure that the rails are aligned with the grooves.
14. Remove the short connector from the connector [12].
• This is the 4-pin connector.
15. Connect the connector and attach the punch waste transport unit (  x 1,  x 1,  x 1).
1. Installation
92
1