Ricoh G148, Service Manual

Page: 179 / 537

Fusing Unit
• Switch off the machine, remove the plug from the power source, then allow sufficient time for the fusing
unit to cool before you remove it from the machine.
Fusing Unit Removal
• Before you begin, spread a mat or some clean paper on the floor where you intend to set the fusing
unit.
1. Open the front door.
2. Pull out the transfer unit.
3. Knob [A] (  x 1)
• Open D3 and D4 until you can see the hole in the shaft.
• Insert the tip of a screwdriver into the hole of the shaft to hold it in position as the knob is turned
to remove or install it.
4. Inner cover [B] (  x 3)
• Pull the fusing unit release lever, then pull the unit out on the rail supports.
• At reassembly, make sure that the harness of the web drive motor is not pinched by the inner
cover.
3. Replacement and Adjustment
178
3