Regulus uREG, User Manual

Page: 84 / 107

uREG User Manual
84
14.3. SYSTEM REPORTS
The
u REG
system has a special group of reports – System reports – whose code (index) is =
0, identified by a DEC or HEX marker. These reports cannot be redefined by the user (at the
stage of
Log CZIP
application development) and are used to indicate malfunctions of the units
and its improper settings.
The key to event codes in system reports is presented in Table 14.3.
Table 14.3.
Attribute
DEC
Attribute
HEX
Meaning
0 0 Undefined system report
1 1 Uaux → Auxiliary power-up and start of initial calibration procedure
2 2 Uaux → Power off
… … Reserved
24 18 Failed settings → Error in main settings
25 19 Failed settings → Error in standby settings
26 1 A Failed settings → Error in auxiliary settings (Transm LCD)
… … Reserved
32 20 Implementation of I2C bus (indication of I2C bus on LCD screen, slot in Reports)
33 21 Fixing settings: Main
34 22 Fixing settings: Backup
35 23 Change bank of settings: Main → Standby
36 24 Change bank of settings: Standby → Main
37 25 Fixing settings: Auxiliary (Transm LCD)
38 26 Fix corrections
… … Reserved
48 30 Error of relays
… … Reserved
56 38 Exceeded 1st threshold for maximum temperature inside the enclosure
… … Reserved
64 40 Fault of LEDs
… … Reserved
72 48 Fault of LCD screen
… … Reserved
80 50 Fault of relays → Improper current of relays
… … Reserved
88 58 Failed reports → Faulty readout of reports
… … Reserved
96 60 5V back to normal
97 61 5V → Supply below 4.70 V
98 62 5V → First instance of exceeded supply v5 V
beyond allowable range 4.75 – 5.25 V
99 63 5V → Supply below 4.55 V
100 64 1.8V → Supply of IF module below +1.75 V
101 65 1.8V → Supply of IF module below +1.85 V
102 66 5 V → Panel supply below +4.75 V
103 67 5V → Panel supply e5.25 V
104 68 12V → Panel supply below +10 V
105 69 12V → Panel supply e14 V
106 6 A Panel temperature below normal
107 6B Panel temperature exceeded
Display backlight will be turned off.