QMS 2060, Supplementary Manual

Page: 66 / 160

)RQW6,006
4063ULQW6\VWHP2SWLRQV
4 Insert the SIMM into the font SIMM connector.
a Hold the SIMM at a 45° angle facing the bottom of the
controller board.
b Slide the SIMM into the Font SIMM connector, and then push
gently on it to seat it securely in the connector.
5 Snap the SIMM into place.
When seated, the SIMM stands upright, firmly in place. If you
cannot snap the SIMM into place, do not force it. Reposition it,
making sure that the bottom of the SIMM is seated completely in
the connector.
6 Insert the controller board in the printer.
Use the instructions in the “Reinstalling the Controller Board” sec-
tion of chapter 2, “Memory and System Software.”
7 Ensure that the Administration/Memory/Manual Config/
K Mem Disk Cache memory client is set to at least 20 KB.
.......................................
.......................................