QMS 2060, Supplementary Manual

Page: 38 / 160

/RFDO7DON
,QWHUIDFH
4063ULQW6\VWHP2SWLRQV
„
A LocalTalk interface card
„
LocalTalk interface notice
The kit may also include additional parts not required for interface
installation on this printer.
» Note: A Phillips screwdriver is needed for this procedure.
,QVWDOOLQJDQ2SWLRQDO/RFDO7DON,QWHUIDFH
0
WARNING: Turn off the printer and unplug the power cord.
ACHTUNG! Bitte schalten Sie den Drucker aus und ziehen Sie den
Netzstecker heraus.
V
Caution: It's very important to protect the printer controller board and
other circuit boards, such as SIMMs and the 1200x1200 dpi Multi-Res
daughterboard, from electrostatic damage while performing this task.
Review the anti-static guidelines in the “Removing the Controller
Board” section of chapter 2, “Memory and System Software.”
1 Turn off the printer, and then disconnect the power cord and
all interface cables from the printer.
2 Access the printer controller board.
Use the instructions in the “Removing the Controller Board” of
chapter 2, “Memory and System Software.”
3 Remove the two screws from the optional interface plate.
Save the two screws. (You’ll use them when you install the
optional interface card.) You can either save or discard the plate.