QMS 2060, Supplementary Manual

Page: 53 / 160

8VLQJD6HULDO
,QWHUIDFH
,QWHUIDFHVDQG'DXJKWHUERDUGV
6SRROLQJ7LPHRXW
Sets the number of seconds the interface waits for data from the host
before terminating a spooled print job.
(QG-RE0RGH
Enables (and identifies an end-of-job sequence) or disables data
stream sensing for the end-of-document (EOD) command.
Choices 00000-99999
Default 00015
Notes This value must be less than K Mem For Spool.
A 00000 value does not turn off the spooling buffer for
the serial interface. If the value is set to 00000, the
printer calculates the Min K Spool automatically at
initialization.
The printer must be restarted for changes to the Min K
Spool menu to take effect. You can either let the printer
restart automatically after you save the change and exit
the Configuration menu, or you can wait for the change
to take effect the next time you manually turn on the
printer.
Menu Administration/Communications/Serial/Spool Timeout
Choices
00000-99999
Default 00030
Menu Administration/Communications/Serial/End Job Mode
Choices None—The printer recognizes only the PostScript ^D
command.
QMS EOD—The printer recognizes only the
QMS%%EndOfDocument command.
HP EOD—The printer recognizes only the HP
<ESC>%12345X command.