Qlogic SANbox 6142, User Manual

Page: 70 / 314

6 – Removal/Replacement
Router Removal and Replacement
6-2 FI0054601-00 A
Q
5. Label all the cables so that they can be connected to the same ports on the
replacement router.
6. Remove all the Fibre Channel and Ethernet cables.
7. Remove the router from the enclosure where it is mounted.
6.2.2
Replacement
Before replacing a router, it must first be removed (perform the procedure in
section 6.2.1 ).
Perform the following steps for installing a replacement router:
1. Mount the router in the enclosure.
2. Reconnect the Fibre Channel and Ethernet cables to the ports where they were
previously connected.
3. Connect the power cable to the router.
4. Using a management station, configure the management port IP address (see
section 4.2) .
5. Using a management workstation, restore the saved configuration or
reconfigure the router as desired (see appendix A.10) .
The replacement router should now be operational.