Qlogic SANbox 6142, User Manual

Page: 290 / 314

C – Configuring CHAP
Configuring CHAP Using CLI
C-2 FI0054601-00 A
Q
a. Click General .
b. Click Secret (in the middle of the screen). If this is the first time you are
setting secrets, reset all secrets.
c. Type the secret ( secret_port ) that you created in step 1 .
4. Click Discovery .
5. Click Add .
6. Type the address of the iSCSI port of the router.
7. Click Advanced .
8. Select Chap Login Information .
9. Type the secret ( secret_initiator ) you created in step 2 into Target Secret ,.
10. Select Mutual Authentication .
11. Click OK .
12. Click OK . The initiator completes the discovery.
C.2.2
CLI—Discovery Session—Uni-directional CHAP
The following procedure describes the steps for configuring single-direction CHAP
used during a discovery session:
1. Do not enable CHAP on the ISCSI port.
2. Use Initiator add :
a. Add the initiator that is about to do discovery.
b. Enable the CHAP for this initiator
c. Create a secret (for example, secret_initiator ).
d. Use Set Chap to update the initiator’s CHAP settings.
3. Go to the MS Initiator.
4. Click Discovery .
5. Click Add .
6. Type the address of the iSCSI port of the router.
7. Click Advanced .
8. Select Chap Login Information .
9. In Target Secret , type the secret ( secret_initiator ) you created in step 2 .