Qlogic SANbox 6142, User Manual

Page: 173 / 314

FI0054601-00 A A-1
Appendix A
Command Reference
The command line interface (CLI) enables you to perform a variety of router
management tasks through an Ethernet or serial port connection. This section
describes the following:
■
Logging On to a SAN Router (see section A.1)
■
Guest Account (see section A.2)
■
Working with SAN Router Configurations (see section A.3)
■
Commands (see section A.4)
A.1
Logging On to a SAN Router
To log on to a router using Telnet, open a command line window on the workstation
and enter the Telnet command followed by the router IP address:
# telnet < ip_address >
A Telnet windows opens prompting you for a login. Enter an account name and
password.
To log on to a switch through the serial port, configure the workstation port with the
following settings:
■
115200 baud
■
8-bit character
■
1 stop bit
■
No parity
Enter an account name and password when prompted.
A.2
Guest Account
Routers come from the factory with the following account already defined:
Account name: guest
Password: password
This guest account provides access to the router and its configuration. After planning
your router management needs, consider changing the password for this account.
The guest account is automatically closed after 15 minutes of inactivity.
See the Password command ( appendix A.17 ) for information about changing
passwords.