Qlogic SANbox 6142, User Manual

Page: 59 / 314

4 – Installation
Installing the SANbox 6142 Router
FI0054601-00 A 4-9
Q
4.2.9
Configure the Router
You can configure the router using the SANsurfer iSCSI/FC Router Manager
application or the command line interface (CLI). To configure the router using the
SANsurfer iSCSI/FC Router Manager, in the
Initial Start dialog box, click Open
Configuration Wizard . Then click Proceed . The Configuration wizard explains and
prompts you for the configuration information listed in table 4-2 :
To configure the router using the command line interface, do the following:
1. Open a command window according to the type of workstation and connection:
❑
Ethernet (all platforms): Open a telnet session with the default router IP
address and log in to the router with the default account name and password
(guest/password).
telnet 10.0.0.1
username: guest
password: ********
❑
Serial – Windows: Open the HyperTerminal application on a Windows
platform. Note, the next few steps may vary according to the version of
Windows you use.
a. Click Start>Programs>Accessories>HyperTerminal>HyperTerminal .
b. Select the connection you created earlier and click OK .
❑
Serial – Linux: Open a command window and enter the following command:
minicom
2. Open an admin session and enter the commands to setup both iSCSI ports
and the management interface. See appendix A for command descriptions.