Qlogic SANbox 6142, User Manual

Page: 32 / 314

2 – General Description
FCIP - Fibre Channel over IP
2-6 FI0054601-00 A
Q
2.5
FCIP - Fibre Channel over IP
The SANbox 6142 Intelligent Router supports FCIP, Fibre Channel over IP. The
FCIP protocol as implemented in the router is not guaranteed nor has it been tested
to be compatible with other vendor FCIP implementations. The router supports a
maximum of two FCIP routes; each route requires a dedicated FC and GE port pair.
■
Merge FC fabrics over LAN/WAN
■
N-port to fabric over LAN/WAN
■
N-port to N-port over LAN/WAN
2.6
Chassis LEDs
The chassis LEDs shown in Figure 2-4 provide information about the router’s
operational status. These LEDs include the input power LED, heartbeat LED, and
the system fault LED. To apply power to the router, plug the power cord into the
router AC power receptacle and into a 100 VAC to 240 VAC, 50 Hz to 60 Hz power
source.
Figure 2-4. Chassis LEDs
2.6.1
Input Power LED (Green)
The power LED shows the voltage status at the router logic circuit board. During
normal operation, this LED lights to show that the router logic circuit board is
receiving the DC voltage from the power supply.
2.6.2
Heartbeat LED (Green)
The heartbeat LED shows the status of the internal router processor and the results
of the power-on self-test (POST). Following a normal power-up, the heartbeat LED