Qlogic SANbox 6142, User Manual

Page: 292 / 314

C – Configuring CHAP
Configuring CHAP Using the GUI
C-4 FI0054601-00 A
Q
C.2.4
CLI—Normal Session—Uni-directional CHAP
The following procedure describes the steps for configuring single-direction CHAP
to be used during a normal session:
1. Do not enable CHAP on the presented target.
2. Use Initiator add :
a. Add the initiator that is about to do a normal login.
b. Enable the CHAP for this initiator
c. Create a secret (for example, secret_initiator ).
d. Use Set Chap to update the CHAP settings of the initiator.
3. Go to the MS Initiator.
4. Click Targets .
5. Select the target you want to login to.
6. Click Advanced .
7. Select Chap Login Information.
8. Type the secret ( secret_initiator ) that you created in into Target Secret .
9. Click OK .
10. Click OK . The initiator completes the normal login.
C.3
Configuring CHAP Using the GUI
The following sections describe the procedure for configuring CHAP using
SANsurfer , the graphical user interface (GUI).
C.3.1
GUI—Discovery Session—Bi-directional CHAP
Perform the following steps to configure bi-directional CHAP during a discovery
session:
1. On the bridge, enable CHAP for the iSCSI port.
2. Select the port in the left column.
3. Click Advanced Configuration .
4. Select Enable Chap .
5. Type a secret in Chap secret (for example, secret_port ).
6. Is the initiator on the discovered iSCSI initiators list?