Qlogic SANbox 6142, User Manual

Page: 58 / 314

4 – Installation
Installing the SANbox 6142 Router
4-8 FI0054601-00 A
Q
4.2.7
Start SANsurfer iSCSI/FC Router Manager
For Windows , double-click the SANsurfer iSCSI/FC Router Manager shortcut, or
select SANsurfer iSCSI/FC Router Manager from the Start menu, depending on
how you installed the SANsurfer iSCSI/FC Router Manager application. From a
command line, you can enter the SANsurfer_Router_Manager command:
<install_directory>SANsurfer_Router_Manager.exe
For Linux , enter the SANsurfer_Router_Manager command:
<install_directory>./SANsurfer_Router_Manager
4.2.8
Connect the Router to AC Power
WARNING!! This product is supplied with a 3-wire power cable and plug for the
user’s safety. Use this power cable in conjunction with a properly
grounded outlet to avoid electrical shock. An electrical outlet that is
not correctly wired could place hazardous voltage on metal parts of
the router chassis. It is the responsibility of the customer to ensure
that the outlet is correctly wired and grounded to prevent electrical
shock.
You may require a different power cable in some countries because
the plug on the cable supplied with the equipment will not fit your
electrical outlet. In this case, you must supply your own power cable.
The cable must meet the following requirements:
■
For 125 Volt electrical service: the cable must be rated at 10 Amps
and be approved by UL and CSA.
■
For 250 Volt electrical service: the cable must be rated at
10 Amps, meet requirements of H05VV-F, and be approved by
VDE, SEMKO, and DEMKO.
To power up the router, connect the power cord to the power receptacle on the
router chassis and to a grounded AC outlet. The router responds in the following
sequence:
1. The chassis LEDs (input power, heartbeat, system fault) light, then all port LEDs
light.
2. After a couple of seconds the heartbeat and system fault LEDs go off, while
the input power LED stays on. The router is executing the POST.
3. After about 45 seconds, the POST is complete and the heartbeat LED starts
flashing at a one second rate. Any other blink pattern indicates that an error
has occurred. Refer to
section 5.3 for more information about error blink
patterns.