Qlogic SANbox 6142, User Manual

Page: 35 / 314

2 – General Description
Fibre Channel Ports
FI0054601-00 A 2-9
Q
Enabling DHCP by this method is not persistent ; to make the change persistent,
use the CLI or SANsurfer Intelligent Router Manager to enable DHCP.
2.7.6
Factory Defaults
To reset the router and restore it to the factory default configuration, use a pointed,
nonmetallic tool to press the maintenance button and
hold it for more than twenty
seconds . The heartbeat LED flashes 20 times. The router boots and is restored to
the factory defaults. The boot time is less than one minute.
The router does the following when restored to the factory defaults:
■
Resets all passwords
■
Resets the maintenance port IP address to 10.0.0.1
■
Disables the iSCSI ports and sets the IP address to 0.0.0.0
■
Erases all presentations
■
Erases all discovered initiators and targets
2.8
Fibre Channel Ports
The SANbox 6142 router has two fibre channel ports. The ports are labeled FC1
and FC2 , and are shown in Figure 2-6 .
Figure 2-6. Fibre Channel LEDs
Each port is served by a small form-factor pluggable (SFP) optical transceiver and
is capable of 1-Gbps or 2-Gbps transmission. SFPs are hot-pluggable. FC ports
can self-discover both the connection type and transmission speed when connected
to public devices or switches. The port LEDs are located to the right of their
respective ports and provide status and activity information.
2.8.1
Fibre Channel Port LEDs
Each port has three LEDs:
■
The amber LED (top) shows activity (data is passing through the port).