Qlogic SANbox 6142, User Manual

Page: 298 / 314

D – Simple Network Management Protocol (SNMP)
Management Information Base (MIB)
D-2 FI0054601-00 A
Q
D.1.2
SNMP Trap Configuration
SNMP trap configuration supports setting up to eight trap destinations. Choose from
Traps 1–Trap 8 to configure each trap.
Table D-2 describes the parameters for
configuring a SNMP trap.
D.2
Management Information Base (MIB)
The following sections describe the QLogic management information base (MIB).
The MIB consists of four object groups:
■
System Information (see section D.2.1)
■
Network Port Table (see section D.2.2)
■
Fibre Channel Port Table (see section D.2.3)
■
Sensor Table (see section D.2.4)
D.2.1
System Information
The system information objects provide the system serial number, version numbers
(hardware/software/agent), and number of ports (FC/GE).
qsrSerialNumber
Table D-2. SNMP Trap Configuration Parameters
Parameter Description
Trap n enabled Enables or disables trap n . If disabled, the trap is not configured.
Trap address
a
Specifies the IP address to which the SNMP traps are sent. A
maximum of eight trap addresses are supported. The default address
for traps is 0.0.0.0.
Trap port
a
The port number on which the trap is sent. The default is 162.
Trap version Specifies the SNMP version (1 or 2) with which to format traps.
Table Notes
a
Trap address (other than 0.0.0.) and trap port combinations must be unique. For example,
if trap 1 and trap 2 have the same address, then they must have different port values.
Similarly, if trap 1 and trap 2 have the same port value, they must have different addresses.
Syntax SnmpAdminString
Access Read only
Description The system serial number.