Qlogic SANbox 6142, User Manual

Page: 164 / 314

7 – SANsurfer iSCSI/FC Router Manager
Wizards
7-94 FI0054601-00 A
Q
Figure 7-88. FCIP Route Add Wizard—Port Selection Dialog Box
Additionally, you can configure the following port route/parameters:
■
FCIP Interfaces FC & GE: provides a dialog box for enabling and
disabling the FCIP route. When the route is disabled the FC and GE
ports are placed in a down state. All route configuration parameters
are retained.
■
GigE Port Programmed Link Rate : provides a dialog box that
contains four options for the GigE link rate; auto, 10, 100 and 1000;
The default link rate is auto.
■
Link Rate Mode : provides a dialog box that contains three options for
the link rate mode; auto, half duplex and full duplex. This dialog box
is available only when the GigE link rate is set to something other than
auto.
■
GigE Port Flow Control : provides a dialog box for enabling and
disabling GigE port flow control. The default is enabled. This dialog
box is available only when the GigE link rate is set to something other
than auto.
After selecting a port pair and setting GE port parameters, click Next to continue.
Or click Cancel to quit the wizard.
3. The Local and Remote IP Address dialog box requests entry of IP addresses
(see figure 7-89) .