Pioneer CDJ-2000, Operating Instructions Manual

Page: 9 / 209

DRB1475-B
En
9
English
9
q CUE/LOOP CALL
c/ d
(page
16
), DELETE (page
16
), MEMORY
(page 16 )
r
VINYL SPEED ADJUST RELEASE/START (page 17 )
s
JOG ADJUST (page 17 )
t
JOG MODE, VINYL mode indicator and CDJ mode indicator
(page
17
)
The mode switches between VINYL and CDJ each time this is pressed. The
indicator for the selected mode lights.
u
TEMPO ±6/±10/±16/WIDE (page 14 )
v MASTER TEMPO (page
14
)
w TEMPO (page
14
)
x
TEMPO RESET and TEMPO RESET indicator
Regardless of the position of the TEMPO dial, tracks are played at the
original playing speed recorded on the disc, etc. The indicator lights when
TEMPO RESET is turned on.
y
Jog dial ( – REV/ + FWD) and JOG RING ILLUMINATION (page 17 )
z
Jog dial display section (page 10 )
Rear Panel
A POWER
w
ON
v
OFF
Press to turn the power on and off.
B
AUDIO OUT L/ R (page 11 )
C
AC IN (page 11 )
D CONTROL (page
18
)
E DIGITAL OUT
F
Kensington security slot
G
LINK (page 11 )
H
USB (page 11 )
Front Panel
I Disc insertion slot
J
Disc force eject pin insertion hole
K
Disc insertion slot indicator
About ejecting discs by force
! If the disc cannot be ejected by pressing [
DISC EJECT
h
], the disc can be
ejected forcibly by inserting the disc force eject pin all the way into the disc
force eject pin insertion hole on the main unit’s front panel.
! When forcibly ejecting a disc, be sure to do so following the procedure below.
1 Press [POWER] and wait at least 1 minute after the set’s
power has turned off.
Never forcibly eject a disc directly after turning off the set’s power. Doing so is
dangerous for the reasons described below.
The disc will still be spinning when ejected and could hit your fingers, etc.,
causing injury.
Also, the disc clamp will rotate in an unstable way, and the disc could get
scratched.
2 Use the included disc force eject pin. (Do not use anything
else.)
The included disc force eject pin is mounted on the CDJ-2000’s bottom panel.
When the pin is inserted all the way into the insertion hole, the disc is ejected
5 mm to 10 mm out of the disc insertion slot. Grasp the disc with your fingers and
pull it out.